I ordered another flight sim addition from them. I really liked the really low platform that came with it and wanted one for the throttle as well. I felt that the throttle was too high with either the shifter platform or the other flight sim platform. Having two of the low mounts is ergonomic nirvana for me. Since I'm for now not using the wheel platform that comes with it, I stuck the throttle mount into one of the receptacles for the table and tightened down my CH Throttle quadrant. I like the angle for the levers in this configuration. There is still swinging room for the keyboard tray but as before, I do have to remove the stick mount which takes seconds. I just swivel the throttle outboard a bit and the keyboard rotates into place for any FPS games I want to play.
That's a Samsung 32" LED TV. I used LED because they are lighter than the LCDs. My only complaint thus far about the cockpit is that it does not seem suited to TVs. The 200x100 VESA pattern just doesn't cut it in a world of larger 200x200 mounting TVs. I had to buy an adapter plate, and a bunch of bolts, etc. The adapter plate had a lot of options so where ever the holes lined up, I put a bolt through it so that I have a lot of bolts holding the plate and TV to the Obutto plate. In the end, I've got 4 M5's and 8 M4's so I hope that's enough. That part was a real pain to deal with - especially given the top and bottom box frames run right across where the 200x200 pattern would go. Hopefully this stays connected. I'm also planning on putting a touch overlay over this monitor so there is a little more weight. I may rig up some type of suspension mechanism for the bottom of the display.
