Have you tried removing the stick's default hardware dead zone? Up until the new T.A.R.G.E.T. release (RC3) this wasn't possible.
I did, and found heaps of difference. At the moment, I'm using the WH exclusively to fly RoF, so I had to set small negative curves in the X & Y axis to make the stick more sensitive through the "bump"; needless to say, this hampered stall fighting somewhat. Well, no need for curves anymore (mind you, I transitioned from an NXT modded Cougar, with which I had to use positive curves, as it required increasingly higher force to move the stick to the extreme offsets).
P.S.: Don't be alarmed by the unstable values reported in the device analyser when the stick is mechanically dead-centered; resolution is so high that in the sim this doesn't matter in the slightest.
Happy new year everyone!
Happy New Year lamarax
I don't think changing the deadzone would have any effect on the very large force change required moving thru the center of travel. Although I would have tried your option, but the Warthog was returned yesterday. My particular Warthog Throttle also had a hat switch that didn't work properly. It's a beautiful piece of kit and I hated to let it go.
Last edited by Chivas; 12/31/1007:50 PM.
Intel core I7 4790K @ 4.4 Asus Maximus Hero VII Motherboard 16 gigs DDR3 2133 EVGA GTX980Ti Oculus Rift LG 37" LCD BLack Mamba III Joystick Cougar Throttle/X55 Throttle/Saitek Levers Saitek Pro Rudder pedals Voice Activation Controls
