Originally Posted By: Orka45

I have "sucessfull" flashed my chip with a test firmware mapping one Axis.

The Device is shown in Settings -> Device and Printer as MMJ-reset...

any ideas whhat i #%&*$# up, gentleman?


Looks that you don't set the "joystick" already. The firmware flash make the Arduino a HID device, but not a "joystick".

Open the JoySetup, select the device "MMJ reset" and set the joystick:

Their name
VID/PID numbers (eg. 0001/0001 make the new joystick the first for Windows/Games).
Number, resolution, names for axis, etc.
Matrix or Shift Register for buttons, set buttons "names" (their numbers). Can leave this for do latter.

Save for device. When reboot the new joystick will appear in Joy Setup testing tools or Windows Control Panel > Games Controllers

Originally Posted By: Forsaken_joystick
I've installed a ps2 thumbstick in there... It isn't pretty but it is functional


Is the solution adopted by Thrustmaster for Cougar. smile

You can order a 3D printed proper cover for the mini-stick:

Early F-16 TQS: http://www.shapeways.com/shops/debolestis
Latter F-16 "Block" TQS: http://www.shapeways.com/product/ARG8VEB84/f16-cursor-knob?optionId=59097861


Last edited by Sokol1; 09/15/16 10:34 PM.